![]() I have a Dell G5 5590 with an i7-9750H and an RTX 2070MQ. Here is how to manually control your fans and set a custom fan curve, instead It reduced performance on the processor permanently, though, and for some takes away the ability to undervolt. ![]() Updating the bios did not fix my fan behavior. The pwm outputs connected to the fan connectors,Īlso, even if I finish the pwmconfig setup and run the fancontrol service, there's no change in the fan behavior. Or the connected fan has no rpm-signal connected to one of There is either no fan connected to the output of hwmon7/pwm1, I've installed fancontrol and tried to set it up as described here: - the pwmconfig tool is able to switch my fans off and on during calibration, however, after calibration it says:.I've installed i8kutils and ran sudo modprobe i8k force=1, now I'm able to see the fan speed in psensor GUI, as on the picture below.I've installed lm-sensors, set it up with sensors-detect and added coretemp to /etc/modules. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |